SP10-38K is a set of 6 asphalt anchors rated at 1,500 lbs. pull. The 6" long anchor is designed to mount plates, fences, machinery directly to asphalt surfaces. For technical information, datasheets and installation manuals, please visit our main website.
Each anchor incorporates a 3/8"-16 UNC female thread,. The thread of the bolt inside the anchor should not exceed 2.5". The anchor requires a 7/8" hole, 6" deep, and the use of a grout such as our EPX2. A 1.4" welded washer at the top of the anchor prevents the anchor from dropping below the surface as well as preventing the anchor from being pulled up into the mounting plate when the bolt is tightened.
The SP10 anchors are mounted flush with the surface of the roadway, so that attached devices can be removed without leaving dangerous screws or protrusions on the walkway.
The SP10-38K is a set of 6 anchors, each pre-installed with a bolt and a washer.